In this guide, we will setup DMVPN Phase 1. In that we have one central hub, with multiple spokes. Spokes will learn about both Hub and other Spoke prefixes via EIGRP. Spoke to Spoke traffic is permitted, however the Hub Read more…
In this guide, I will show how to implement basic Policy Based Routing on a Layer 3 Switch. Here is the topology we will work on: In this scenario, we have two routers connected to a core switch. We then Read more…
When using BGP and peering with multiple ISPs at the edge, you can use a feature within BGP that allows you to advertise networks to a neighbour dependent on the existence of a route in the BGP RIB. This is Read more…
When you peer with a Service Provider using BGP. They will likely ask you if you want the full BGP table, a partial table or just a default route. Most devices you have on your companies edge, will not be Read more…
When you peer with a Service Provider using BGP. They will likely ask you if you want the full BGP table, a partial table or just a default route. Most devices you have on your companies edge, will not be Read more…
VRFs are an excellent tool for Layer 3 separation on a router. Allowing you to separate routing domains and control where traffic can be routed, much like VLANs on a Switch. VRFs are also required for MPLS L3VPN deployments. There Read more…
VRFs are an excellent tool for Layer 3 separation on a router. Allowing you to separate routing domains and control where traffic can be routed, much like VLANs on a Switch. VRFs are also required for MPLS L3VPN deployments. There Read more…
I am going to walk through how the LSP (Label Switched Path) is found on Cisco devices running LDP and go through a practical demonstration. First, lets look at our topology: In this demonstration we are looking at the path Read more…